building construction project 1

2. PAGE
1
2
4
7
9
14
18
21
22

3. 1

4. 2

5. Improvisation of the structure shape is made in
order to realise structural wise where proper
joints are needed to connect the members.
The final design comprise of slanted frame
(roof) where distribution of the forces and
loads are discussed beforehand.
3

6. 4
FLOOR PLAN

7. 5
FRONT ELEVATION

8. 6
CONSTRUCTION DETAILS

9. 7

10. L- shaped brackets Flathead screws
(6x30mm, 3.5x16mm)
¾’’ round head nailFlat brackets
8

11. 9Air gap to prevent ingress of moisture into the column

12. 10

13. 11

14. Beam-to-column connection
Cross-halving used to joint the roof frame. L-shaped bracket was used
as connector to connect the roof to the main column. It will support the
column when load is being transferred directly from the roof to the
floor.
12
Flat-shaped bracket used to connect between roof frame to
another part of the column. Roof joist are attached onto the
roof frame by cutting it to angle the slanted roof structure.
The two secondary columns are angled and
attached to the floor using screw. The secondary
columns that also connected to roof frame will
carry the load directly from roof to the floor. It
provides support and stability to the structure.
The top of two secondary columns
are attached to the roof frame
using the flat-shaped bracket.

15. 5.4 ROOF
On top of the roof frame, a vertical column added to increase the height of
structure. It also to make the roof slanted by making one side is higher than the
other side.
The butterfly roof being supported by the roof
joist equally on each side connected using nails.
Polycarbonate roof is used because it can resist
weather condition better and long lasting.
The cutting of roof joist are
angled according to the
height of roof frame.
13

16. 14

17. 15

18. 16

19. 17

20. 18

21. 19
Wind from all
directions
rainwater

22. 20

23. 21

24. 22

25. 23